add manual mounting to stay alligned setup

[Aed-1]

adds #1673

clicking the "manual mounting" button makes that modal pop up where you do your stuff, then the "done" button closes the modal and takes you to the next step

[ImSapphire]

Doesn't seem to be working quite right for me, when I click on an assignment point the prompt appears behind the Manual Mounting modal:

[Aed-1]

well thats not supposed to happen..
il look at it later today

[ImSapphire]

On the mobile UI (when the window is too small horizontally), the Done button may be underneath the thigh/ankle assignment points, causing it to be unclickable

[Aed-1]

have a go now

[ImSapphire]

hmm, if the user clicks on the Mounting Calibration reset button, then during the countdown goes to Manual mounting and clicks Done, when the automatic mounting calibration finishes it will skip a step. Perhaps the 'Manual mounting' button should be disabled when a reset is pending

[Aed-1]

ive made it so that once you press the mounting reset button, the manual reset button will disable, and ive also made sure it re-enables once the timer is up so that if you decide to go back, the button wont still be disabled

[ImSapphire]

works great! Only issue I can notice with the Stay Aligned setup flow is that you can click a reset button then go back to previous page which messes up the flow a bit, but it's not caused by this PR nor is it really a big issue

[Aed-1]

if you want i can quickly set the "previous step" button to disabled while resetting but that might be scope creep

[ImSapphire]

since it's an existing issue I think it's fine to do that in a follow-up

[ImSapphire]

Found another edge case: click mounting calibration, go to previous step and then click full reset. The 'manual mounting' button stays disabled. I think ResetButton should have an onCancelled callback, so we can do setDisableMounting(false) when the reset is cancelled.

Disabling the 'Previous step' button during the reset would prevent the user from going back and clicking full reset, however resets can also be triggered by other software through SolarXR

[Aed-1]

surely the second option would still be viable as if your triggering resets through a seperate program, there will be no manual mounting button to grey out