G1 vice G0

[steven4u2nv]

I am running Klipper. It seams it prefers G1 over G0. Additionally the starting height for the "Blob" could start higher. I don't think sticking to the bed is necessary. I do understand and agree with the wipe after the purge, so if it doesn't change I undertand.

[Schnabulation]

I also just tried to get the tool to work with Klipper but I faced different errors. For one, it doesn't know M109 with the R-parameter. Only the S-parameter. Also it seems that Klipper disconnects when a command takes too long - which is the case for printing the first "Blob".

[blalor]

@steven4u2nv G1 and G0 are the same command in Klipper. What behavior are you seeing?